石国辉,张永安,李锡武,李志辉,闫丽珍,闫宏伟,刘红伟,熊柏青.Al-9.4Zn-1.9Mg-2.0Cu合金的热变形流变行为与本构方程[J].稀有金属材料与工程,2019,48(9):2753~2758.[Guohui Shi,Yongan Zhang,Xiwu Li,Zhihui Li,Lizhen Yan,Hongwei Yan,Hongwei Liu,Baiqing Xiong.Flow behaviors and corresponding constitutive equation of the Al-9.4Zn-1.9Mg-2.0Cu alloy[J].Rare Metal Materials and Engineering,2019,48(9):2753~2758.]
Al-9.4Zn-1.9Mg-2.0Cu合金的热变形流变行为与本构方程
投稿时间:2019-02-20??修订日期:2019-07-01
中文关键词:??Al-Zn-Mg-Cu合金??热压缩变形??流变应力行为??本构方程模型
基金项目:
中文摘要:
??????本文对Al-9.39Zn-1.92Mg-1.98Cu合金做等温热模拟压缩实验,变形温度为300 ℃~460 ℃,应变速率为0.001 s-1~10 s-1,变形量为60%。结果表明:变形时,合金的流变应力力随着变形温度的降低或应变速率的增大而增大。由于热变形时存在摩擦影响,对流变应力曲线进行修正.结果发现摩擦修正后的应力值低于实验值,摩擦力对流变应力的影响程度随着温度的降低和应变速率的增大而增大。基于经典的Arrhenius方程,考虑应变量对材料常数(α,n,Q和A)的影响,构建该合金在热变形时的本构方程。评价改进的本构方程预测能力发现流变应力值与实测值吻合度较高,其相关度高达93.5%。
Flow behaviors and corresponding constitutive equation of the Al-9.4Zn-1.9Mg-2.0Cu alloy
英文关键词:Al-Zn-Mg-Cu alloys??Hot compressive deformation??Flow stress behaviors??Constitutive equation model
英文摘要:
??????Hot compression tests of the Al-9.39Zn-1.92Mg-1.98Cu alloy are carried out in the temperature range from 300 ?C to 460 ?C and the strain rate range from 0.001 s-1 to 1 s-1, and the height reduction degree is 70%. The flow stress is corrected because of the effect of friction. Results show the flow stress decreases with increasing the temperature increasing or decreasing the strain rate. The friction effect is more and more obvious when the temperature is low and the strain rate is high. A revised constitutive equation considering the influence of strain is established based on the Arrhenius-type model. Compared with the experimental and predicted flow stresses, the revised constitutive equation has a higher accuracy. Their correlation coefficient and average absolute relative error is 0.95 and 2.45%, respectively.
作者单位E-mail
石国辉?有研工程技术亚洲AG手机|开户有限公司有色金属材料制备加工国家重点实验室?sgh528100@163.com?
张永安?有研工程技术亚洲AG手机|开户有限公司有色金属材料制备加工国家重点实验室??
李锡武???
李志辉???
闫丽珍???
闫宏伟???
刘红伟???
熊柏青???
摘要点击次数:?81
全文下载次数:?1
查看全文??查看/发表评论??
关闭